Boost converter design and analysis schematic with inductor and diode current waveforms
Posted in

Boost Converter Design Calculator

Boost Converter Design Calculator

Enter your specs. Every value, rating, loss and the waveform updates live as you type.

1. Specifications
2. Topology and devices
3. Operating point

    Live circuit

    Operation mode: switching period

    Q1 on (energy into L)Q1 off, L + Vin feed the outputIdle, zero current (DCM)
    Duty cycle
    Inductor ripple ΔI
    Output ripple
    Input current
    RHP zero

    Component value selection

    Inductor L
    Inductor current rating
    Output capacitor
    Input capacitor
    Low-side MOSFET Q1
    Schottky diode D1

    Voltage and current of each device

    Power, losses and temperature

    Efficiency
    Pout ÷ Pin at this load.
    Input power
    Total loss
    Q1 junction temp.
    Q2 / D1 junction temp.
    Q1 conductionQ1 switching + CossGate driveQ2 / D1Inductor DCRCapacitor ESR

    Live waveforms

    Estimates for first-pass design. Core loss, dead-time, diode reverse recovery and layout parasitics are not modeled, so expect real efficiency a little lower. A boost has no short-circuit protection by itself: Vin always reaches Vout through L and the diode. Confirm with your controller datasheet.

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    This site uses Akismet to reduce spam. Learn how your comment data is processed.

    electronics believer