Inverting buck-boost converter schematic with negative output and switching waveforms
Posted in

Inverting Buck-Boost Design Calculator

Inverting Buck-Boost Converter Design Calculator

Enter your specs. Every value, rating, loss and the waveform updates live as you type.

1. Specifications
2. Topology and devices
3. Operating point

    Live circuit

    Operation mode: switching period

    Q1 on (energy into L)Q1 off, L feeds the outputIdle, zero current (DCM)
    Duty cycle
    Inductor ripple ΔI
    Output ripple
    Input current
    RHP zero

    Component value selection

    Inductor L
    Inductor current rating
    Output capacitor
    Input capacitor
    High-side MOSFET Q1
    Schottky diode D1

    Voltage and current of each device

    Power, losses and temperature

    Efficiency
    Pout ÷ Pin at this load.
    Input power
    Total loss
    Q1 junction temp.
    Q2 / D1 junction temp.
    Q1 conductionQ1 switching + CossGate driveQ2 / D1Inductor DCRCapacitor ESR

    Live waveforms

    Estimates for first-pass design. Core loss, dead-time, diode reverse recovery and layout parasitics are not modeled, so expect real efficiency a little lower. The output is negative with respect to GND. Unlike a boost, Q1 disconnects the input when it turns off, so output short-circuit protection is possible with current limiting. Confirm with your controller datasheet.

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    This site uses Akismet to reduce spam. Learn how your comment data is processed.

    electronics believer